LIGHTLAB SETTINGS
1. Press “Export User Data” to export all test results from the LightLab. NOTE:
“Export Diagnostic Data” will export a file that will not be readable by a user.
The exported file is intended to be sent to an Orange Photonics support
representative and contains raw instrument and diagnostic data.
2. Once selected, the data will be begin to transfer to the SD card. Depending on the
number of tests that have been completed this may take a few minutes.
RESET COUNTER
LightLab keeps track of the number of tests that are remaining in the Selective
Separation Column. The tests remaining are shown in the upper right corner of each
screen. If the counter reaches zero, a prompt to replace the column is displayed when a
test is started. Occasionally the counter may be incorrect. To reset the counter to 25
tests, press the Reset Counter button.
DEVICE NAME
LightLab allows a unique name to be created for each instrument. This allows
customers with multiple sites to keep track of units with easy names. The device is
To Next Page
Loading...