SHUTTING DOWN
9. Shutting Down
If LightLab is typically left in one location, it does not need to be completely packed
away and can remain set up. If the device will be used again in less than one day, we
recommend simply turning off the analyzer. If the device will not be used for more than
a day we recommend removing the LightLab Solvent cap and replacing it with the
storage cap to avoid excessive evaporation. The column can remain in place in either
case.
To completely shut down and pack away LightLab use the following steps:
1. Turn off LightLab and unplug system.
2. The power brick and plug can be stored in the right side of the storage
compartment.
To Next Page
Loading...