LIGHTLAB SETTINGS
SOUNDS ON/OFF
LightLab has audible sounds that indicate when a zero or test is complete. These can be
turned off by pressing the “Sounds ON/OFF” button. A beep will confirm that the sound
is on when pressed.
PROMODE ON/OFF
ProMode, when enabled, provides abbreviated on-screen instructions for users that are
experienced with LightLab operation. All instructional steps are skipped so that a test
can be completed with a minimum number of button presses.
MOISTURE CORRECTION ON/OFF
LightLab allows correction for the moisture content of any plant material. When this
setting is enabled, an additional screen will appear that requests moisture content
information as shown below. When a moisture content is entered, it will correct the
same as if it were completely dry. LightLab will correct the results by adjusting the
sample weight to only include non-moisture weight. For example, if a plant that
contains 15% THCA by weight has a moisture content of 10%, if 100mg was weighed
and entered into LightLab, it will correct the weight to 90mg (100mg*(100%-10%)).
The result is a slightly higher value. In our example of 15% THCA, the result will be
16.7% (15%*(100mg/90mg)).
We recommend only using moisture correction if the value is known to avoid inaccurate
results. We recommend only using a gravimetric based moisture analyzer for the most
accurate results. Moisture correction is available for Flower, Wet Flower (always on),
Trim, Raffinate and Custom (always on).
NOTE: if a moisture content >25% is entered, LightLab will require 500mg of sample.
To Next Page
Loading...