COMPLIANCE AND SAFETY INFORMATION
13. Compliance and Safety Information
SAFETY INFORMATION
The use of the LightLab involves solvents and laboratory equipment. Proper
understanding of the system and operation is critical to safety. The LightLab solution
contains methanol and should be handled with caution. The Safety Data Sheet (SDS) for
LightLab solution can be found here:
OrangePhotonics.com/s/SDS.pdf
The following safety considerations should be followed to ensure safe operation of the
LightLab:
- Please read and understand this manual before using the LightLab.
- Wear latex or similar gloves and eye protection when using the device
- Never operate the device near or in the same room as open flames.
- Use care when handling LightLab solvent, it contains methanol and is flammable.
- Use the LightLab in a well-ventilated area.
- Dispose of any methanol waste per your state or local laws.
- Never use a LightLab that is damaged or operating erratically. Never use the
device for anything but it’s intended use.
- Do not open the LightLab, harmful UV rays may be present inside the device.
COMPLIANCE INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
To Next Page
Loading...