SAMPLE ANALYISIS- INFUSED PRODUCT
7. Sample Analysis- Infused Product
Infused product should be selected when analyzing products infused with cannabis, for
example tinctures or edibles. Infused products may require specialized sample
preparation techniques. Infused product setting reports samples in mg/g to facilitate
easy conversion to dosage. For example, a sample that reads 2mg/g and has a weight of
5g would have a total dose of 10mg (2mg/g*5g). We recommend validating any sample
preparation and analysis before routine analysis. Some samples may not be possible to
measure with a standard LightLab analyzer. Contact Orange Photonics support if
assistance is required.
NOTE: Infused Product is an advanced analysis that may require modifications to the
procedure below depending on the data/reporting required. It is not recommended for
novice LightLab users.
1. Select “Other” as the sample type for the main screen.
2. Select the type of sample to be measured from the new list that appears (Infused
Product for this section). NOTE: if tests remaining is zero, you will be prompted
to replace the column, see Section 11
To Next Page
Loading...