SAMPLE ANALYISIS- CUSTOM
8. Sample Analysis- Custom
Custom should be selected when analyzing products that fall outside of any standard
LightLab measurable products. Custom analysis may require specialized sample
preparation techniques. We recommend validating any sample preparation and
analysis before routine analysis. Some samples may not be possible to measure with a
standard LightLab analyzer. Contact Orange Photonics support if assistance is required.
NOTE: Custom is an advanced analysis that may require modifications to the procedure
below depending on the data/reporting required. It is not recommended for novice
LightLab users.
1. Select “Other” as the sample type for the main screen.
2. Select the type of sample to be measured from the new list that appears (Custom
for this section). NOTE: if tests remaining is zero, you will be prompted to
replace the column, see Section 11
To Next Page
Loading...