SAMPLE ANALYISIS- WET FLOWER
5. Sample Analysis- Wet Flower
Wet flower analysis should be used for any living cannabis plant before or just at
harvest time
NOTE: Wet flower is an advanced analysis that may require modifications to the
procedure below depending on the data/reporting required. It is not recommended for
novice LightLab users.
1. Select “Other” as the sample type for the main screen.
2. Select the type of sample to be measured from the new list that appears (Wet
Plant for this section). NOTE: if tests remaining is zero, you will be prompted to
replace the column, see Section 11
To Next Page
Loading...