SAMPLE ANALYISIS- RAFFINATE
6. Sample Analysis- Raffinate
Raffinate analysis should be used for plant material which has previously been
extracted using CO2, Butane, Ethanol, etc. Raffinate is typically tested to ensure
extraction was run to completion. The addition of 200mg rather than the 100mg used
for Flower analysis allows a detection limit of 0.5% (flower has a detection limit of 1%)
1. Select “Other” as the sample type for the main screen.
2. Select the type of sample to be measured (raffinate for this section). NOTE: if
tests remaining is zero, you will be prompted to replace the column, see Section
11
To Next Page
Loading...