LIGHTLAB SETTINGS
shown in the upper right-hand corner of most screens and is saved with any test results.
To change the name, press the “Device Name” button and enter a new name.
SUPPORT
If a problem occurs that cannot be corrected using this manual, press the Support
button to display Orange Photonics support information. The support screen will also
display information that may be useful to the support specialist.
UPDATE
LightLab internal software and calibrations are updated via the User SD card located on
the right side of the instrument. Update files are provided by Orange Photonics support
and should be placed on the SD card via your computer. Once the SD card contains the
update file, insert the SD card into the LightLab. Plug in the LightLab to external power
(do not update while operating on battery) and select the “Update” button. LightLab
will update and reboot. The process may take several minutes.
To Next Page
Loading...