LIGHTLAB SETTINGS
4. Close column holder onto Selective Separation Column.
5. LightLab will flush new column for 90 seconds, and will be ready for a new
sample once complete.
FLUSH SYSTEM
If the LightLab performs poorly, indicates that results were marginal or LightLab solvent
does not flow through system, the instrument may need to be flushed. Flushing the
system forces solvent through the device at full pressure to dislodge any debris that may
be in the fluid lines. Flushing is not required under normal conditions, contact Orange
Photonics Support for help if you are having issues with performance.
If it becomes difficult to inject a sample, the input may need to be cleared. Clearing the
input forces LightLab solvent out of sample input to dislodge any debris in the sample
input lines.
To Next Page
Loading...