SHUTTING DOWN
3. Remove Selective Separation Column and place red caps on the column. Close
column holder.
NOTE: It is important to keep the column wet for best performance. Always
immediately replace red caps when storing the column, do not store without
caps in place. The column can be stored in the small hole near the center of the
instrument.
4. Remove fluid lines and place in cap baton. Placing them in partway and tapping
the baton on the table allows them to slide to the bottom of the baton.
5. Remove solvent cap and place in baton. Place storage cap on solvent bottle and
tighten firmly.
To Next Page
Loading...