Orion Machine Manual
Revision 3.0 Flex Stretchwrapper
15 February 2016 Introduction and Safety
Page 1-5
System Safety Recommendations
Safeguarding personnel that operate and/or maintain automated equipment is the primary
consideration. Because it is very dangerous to enter the operating space (work envelope)
of a machine during operation, adequate safeguards must be in place and safety precau-
tions must be observed.
The following general precautions are recommended for all personnel who perform sys-
tem operation or maintenance.
• Do lockout-tagout procedures whenever you do maintenance and repair work.
• All personnel who repair, maintain, or operate the equipment need to know the loca-
tion of all EMERGENCY STOP buttons.
• Do not operate the equipment with any of the safety guards removed.
• Do not wear neckties, loose clothing, or long loose-hanging hair around any equip-
ment.
• Observe and follow the DANGER, WARNING, and CAUTION messages throughout
this manual, in vendor manuals, and displayed on the equipment.
• DO NOT use steps or stands that allow anyone to reach over guards.
• Personnel should attend all available safety and operational training courses.
• Personnel should know and follow the recommended safety procedures whenever
they must enter the packaging systems motion area.
• Personnel should not enter the packaging system while control power is "ON".
• Personnel should not power up the system if someone is in the working path of the
machine
• The system should be powered down when not in use.
• Personnel should pay special attention to all the posted warnings and cautions located
on any devices. Observe all safety and/or precautionary steps and procedures when
working with the system.
• Personnel should keep the system clean to make it easier to spot hazards.
To Next Page
Loading...
Need help?
General
