Orion Machine Manual
Revision 3.0 Flex Stretchwrapper
15 February 2016 Introduction and Safety
Page 1-13
Assembly Procedure
Note: The structural frames of the machine have to be installed on a lev-
eled floor. The base deviation from vertical must not exceed 1/4" on
the distance of 10 feet (angle: 0 degrees 6').
Move the wrapper into its final position. If the wrapper is to be secured to the floor, we
recommend that the wrapper base section be bolted to the floor by the 1/2" concrete floor
anchors (leg & shield or expandable type-Red Heads).
To Next Page
Loading...
Need help?
General
