Operator Manual
Chapter: Equipment specification
s
Do not use toxic or inflammable gases such as: Hydrogen, Oxygen, Fluorine, Chlorine, every type of hydrocarbon gas, any mixture of Hydrogen
and Nitrogen.
Do not use Nitrogen during welding. Do not put inflammable material along the LASER beam path. Don not use toxic materials or materials that
emit explosive gases. Do not stare at the LASER beam without protective eye wear.
Do not leave clothing of any kind along the LASER beam path. Do not introduce any living or dead organisms into the LASER beam. Do not use
the LASER welder to heat food. Do not use the LASER welder to dry clothes and materials in general.
Labels and safety devices:
1. Emergency button, use only in the event of an emergency. If pressed, it disconnects the power
supply network from the device. ETI00361
2. LASER aperture warning label (ETI00129):
LASER APERTURE. This label indicates the LASER beam outlet point
3. LASER emission characteristics label (ETI00528):
This label provides information about the emission characteristics of the laser beam, including:
• The energy emitted (E)
• The wavelength (λ)
• The duration of the pulse (t)
• The average power (P)
Moreover, it states the reference standard for LASER product safety.
4. Laser device classification label (ETI00131):
LASER RADIATION. AVOID EYE OR SKIN EXPOSURE TO DIRECT OR SCATTERED RADIATION.
CLASS 4 LASER EQUIPMENT.
This label indicates the dangers that the laser system could have if it is used incorrectly. In fact,
the laser generator used in this equipment is the Class 4 energy level.
5. Data plate label:
This label contains the machine construction data.
6. Label that indicates the type of liquid to use:
ETI00276 This label indicates the use of deionised water only.
7. High voltage warning label ETI00130
To Next Page
Loading...
