OROTIG EVO X - Page 32

Operator Manual
Chapter:
Di agnostics
32
W arning 9: Water temperature too high
S ymptom:
The temperature of the coolant is too high.
S o luti on:
Wait for the equipment to reset automatically, do not switch off, leave it on to quicken up the cooling process.
If it does not take place automatically, contact the technical after-sales assistance.
C o de 10: Not managed.
Code 11: Not managed.
Warning 12: UV Lamp
S ymptom:
Problems with UV lamp switch-on.
S o luti on:
Contact the technical after-sales assistance.
Warning 13: Cooling fan
S ymptom:
Operating problems of the rear cooling fan.
S o luti on:
Contact the technical after-sales assistance.
Warning 15: Safety panel Open
S y mptom
The chamber door is open.
S olution
Close the door.
WARNING! The equipment must NOT be installed in an environment that is too hot and away from heat sources; the higher the ambient
temperature, the lower the efficiency of the cooling circuit/heat exchanger will be.