932502G / 0618 7. FIRMWARE COMMANDS AND RESPONSES
Responses:
$N001001088052<CR> Date reported as Jan 1, 1988.
... ...
$N031012099059<CR> Date reported as Dec 31, 1999.
$N001001000036<CR> Date reported as Jan 1, 2000.
... ...
$N031012087056<CR> Date reported as Dec 31, 2087.
SHOW_DELAY_COLLECTION
Shows the width of the PUR signal setting. See also SET_DELAY_ COLLECTION.
Responses:
DEL_COLL 0000000000001.6
SHOW_DELAY_SAMPLE
Shows the Delay Sample setting. See also SET_DELAY_SAMPLE.
Responses:
$C00003090 The sample number is 00003, and 090 is the checksum.
SHOW_DET_SNUM
This command responds with the detector serial number stored in the SMART-1 DIM.
Response:
$FP40175 Serial number P40175.
SHOW_DET_VERSION
Returns the DIM firmware version (if a DIM is connected).
Examples:
$FNAID000 NaI DIM firmware version.
$FSMDT000 SMART-1 firmware version.
SHOW_DEVICE
Shows the currently selected device. Always 1 for DSPEC 50.
SHOW_DISPLAY
No function in the DSPEC 50; included for backward compatibility.
SHOW_ETP
Reports if Enhanced Throughput Mode is enabled.
Responses:
$IF Enhanced Throughput Mode disabled.
$IT Enhanced Throughput Mode enabled.
103
To Next Page
Loading...
