OTT Pluvio 2 S - Page 34

䊳
Set/read serial interface (SDI-12 or RS-485)
aOCLb! ab<CR><LF> Set serial interface
aOCL! ab<CR><LF> Read serial interface
a– sensor address
b – 0 = SDI-12; factory setting
1 = RS-485 2-wire
2
= RS-485 4-wire
䊳
Set/read protocol on RS-485 interface
aOCMb! ab<CR><LF> Set protocol
aOCM! ab<CR><LF> Read protocol
a – sensor address
b – 0 = SDI-12 protocol; factory setting
1 = ASCII (RS-485 command line mode)
䊳
Set/read data transmission rate (baudrate) at RS-485 interface using the ASCII-protocol
aOCRb! ab<CR><LF> Set data transmission rate
aOCR! ab<CR><LF> Read data transmission rate
a – sensor address
b – 0 = 1 200 bit/s
1 = 2 400 bit/s
2 = 4 800 bit/s
3 = 9 600 bit/s factory setting
4 = 19 200 bit/s
5 = 57 600 bit/s
6 = 115 200 bit/s
䊳
Reset Accu total NRT
aOMR! a<CR><LF> Reset Accu total NRT
a – sensor address
34