E-215-7-E
18
(6) To perform a repeated metering of the last measured batch, all you need is to press the reset key to
bring the total counter of LCD 2 back to zero and then press the start key:
Press
RESET
◀
key to reset the total counter.
Pressing
START
▲
key readies to restart the last metered measurement.
NOTE: For metering different batches, select a new target batch setting each time.
(7) Emergency shutoff (or temporary interruption)
To bring the controller to an emergency stop, press
STOP
ROT.
key. The shutoff valve will come to a full
closure.
Pressing
START
▲
key will resume operation and continue metering the remaining quantity from the
point of interruption.
In this way, safe and accurate measurement can be achieved.
To Next Page
Loading...