D
Darren SchmidtJul 29, 2025
What to do if my Overhead door CD power head is not powered?
- CChristopher MarquezJul 29, 2025
If the power head is not powered, check the breakers, fuses, and plugs.
To Next PageTo Next PageWhat to do if my Overhead door CD power head is not powered?
If the power head is not powered, check the breakers, fuses, and plugs.
What to do if the beam is obstructed on my Overhead door CD?
If the beam is obstructed, check for any obstructions that may be blocking it.
What to do if power has been interrupted to my Overhead door Garage Door Opener?
If power has been interrupted, remove power and then reapply it to the garage door opener.
What to do if wiring from power head is bad in Overhead door CD Garage Door Opener?
If the wiring from the power head is bad, check the wiring for any obvious shorts.
What to do if wiring to source is missing or bad in Overhead door CD?
If the wiring to the source is missing or bad, check the wiring.
What to do if the sensor is receiving interference in my Overhead door CD Garage Door Opener?
If the sensor is receiving interference, attempt to determine the source of the interference.
What to do if the wire to sensor is missing or bad in Overhead door CD Garage Door Opener?
If the wire to the sensor is missing or bad, check the wiring.
General| Drive System | Chain Drive |
|---|---|
| Horsepower | 1/2 HP |
| Warranty | Limited 5-year motor warranty, 1-year parts warranty |
| Voltage | 120V |
| Lighting | 100-watt (max) light bulb |
| Motor Type | AC |
| Speed | 7.0 in/second |
| Battery Backup | No |
Details potential hazards associated with garage door operators, including moving doors and electrical shock.
Provides critical safety instructions for installing garage door operators to prevent severe injury or death.
Instructions for assembling the channel and power head components of the operator.
Instructions for assembling the rail and power head components of the operator.
Specific instructions for installing the operator on track guided garage doors.
Specific instructions for installing the operator on trackless garage doors.
Instructions for mounting the Safe-T-Beam® system brackets to the garage door frame or wall.
Guidance on positioning the STB source and sensor modules for optimal operation.
Guide to diagnose and resolve issues with the Safe-T-Beam® system using self-diagnostic codes.
Setting the minimum force required for the operator to open the garage door.
Setting the minimum force required for the operator to close the garage door.
Ensures the door reverses upon contact with an obstruction during closing.
Key safety guidelines for operating the garage door opener, including child safety.
