Owandy One - Page 15

EN
ONE – User manual Page 15/44
Warning
To avoid interferences in the image, do not use the system close to strong magnetic fields and avoid
proximity to electrostatic emission sources.
Warning
Read paragraph 1.9 to ensure the installation complies with the standards
Install your imaging software before the installation of the kit, its drivers and O.S.P. tools and the installation files of
the sensor.
3.1.1 Recommended minimal configuration
Warning
Any computer configuration that does not comply with the minimal recommended configuration can
prevent the starting or proper functioning of the sensor kit. Verify the specifications of the computer(s)
before the installation.
Operating system
Windows 7, 8, 10 / 32 and 64 bits
Computer
Motherboard
USB port
Compliant -IEC60950-1
Intel 3GHz Chipset and processor
USB 2.0 High-Speed
Graphics card
Monitor
1 GB
High resolution 1024x768 (15inch)
RAM memory
Hard disk
2 GB
500 GB
CD-ROM drive
Backup system
24x
External/removable disk,
CD-ROM/DVD…
Printer
Keyboard and mouse
Laser, inkjet, thermal
Warning
The computer connected to the sensor MUST be compliant with standard IEC 60950-1.
If your computer does not possess USB 2.0 ports, these can be added as PCI/PCI express cards (for desktop
computers) or PCMCIA cards (for laptops). The PCMCIA cards need to be powered by an external power supply if
they do not provide enough current. Please contact your IT specialist for further information.
3.1.2 Setup guidelines
The computer and the screen with which the sensor and the box are used should preferably be situated close to the
chair, within the field of vision of the practitioner, to allow for immediate use. Provide visual access for the patient
to be able to share the radiological information with him/her.