Owandy One - 3.4 Configuration in the Owandy imaging software

EN
ONE – User manual Page 21/44
The “ONE USB” is installed under “Universal Serial Bus controllers” in the “Device manager”. To reach this window
click on the Workstation icon with the right mouse button and select “Manage” in the drop-down menu. In the
window that appears select “Device manager”.
3.3.2 Sensor installation files
Warning
Each kit is provided with a sensor installation USB stick of its own; the serial number of the sensor is
written on the USB stick and on the connection box. You can therefore not use the same USB stick to
install several sensors; each sensor requires its own USB stick.
Before installing the sensor installation files, make sure that:
 The drivers of the kit are installed.
 The imaging software is not started.
1. Insert QuickVision USB stick
2. Open CALIBRATION partition
3. Click on install.bat
4. Close the window
3.3.3 O.S.P. update
If you need to update your O.S.P.:
1. Connect QuickVision USB stick to the PC
2. Launch “autorun.exe”. Select ONE button
3. Click on “Install or Reinstall” and follow the instructions on-screen.
3.4 Configuration in the Owandy imaging software
To be able to use your kit with the Owandy QuickVision imaging software you must configure your equipment.
1. Start the imaging software (double-click on the desktop icon or use the link in Start / Programs /
QuickVision).
2. Click on the “SETUP” button in the main screen.
3. Select “Owandy Digital Intraoral” under the “Intra-Oral sensor” option in the window that appears.