EN
ONE ā User manual Page 24/44
To enable the sharing of a kit between different workstations, it is necessary to first install the imaging software for
the acquisition of the images, the drivers, O.S.P. tools and sensor installation files on all the computers with which
your ONE will be used.
4 Use
4.1 Precautions
Warning
ALWAYS use protective sheaths to cover the sensor, the part of the cable proximal to the sensor and the
positioner, if used.
Warning
ALWAYS keep (or ask the patient to keep) in place the protective sheath during the use.
Warning
Make sure the sensitive surface (the flat surface) of the sensor is directed towards the X-ray generator.
The active surface of the sensor is marked by a frame. The back of the sensor (rounded) does not react
to X-rays and does not produce an image on-screen.
Warning
The kit must be manipulated with care, minimising the twisting, pulling and bending of the attachment
cable. Do not step or roll on the cable. Be careful not to pull on the cable when removing the hygienic
protective sheaths.
Warning
Do not pull on the cable itself, but on the plug to disconnect the USB cable.
Warning
Even though the sensor is resistant to impacts, it is strongly recommended to not let it fall on the floor.
If a physical impact should exceptionally happen, contact your distributor and do not try to intervene
yourself.
Warning
Do not ask the patient to bite on the sensor or cable.
Warning
Use of a mobile phone or an RF communications device near the ONE sensor may affect the sensor.
To Next Page
Loading...