19
Check engine oil, hydraulic oil
and belt oils
!
CAUTION
Ensure that the outboard is in
vertical position when checking
engine oil level, gear oil level and
upper and lower belt oil level.
Check engine oil
1. Remove the engine oil dipstick
and wipe it clean.
2. Completely insert the dipstick
and remove it again.
NOTE! Be sure to completely insert
the dipstick into the dipstick guide.
3. Check that the engine oil level
is between the upper and the
lower mark on the dipstick. If
below the lower mark, fill up
with engine oil.
4. Wait a few minutes until the
oil has run down. If oil level
is above dipstick upper mark
drain appropriate amount of
oil. Excess oil level can cause
reduced performance and oil
leakage.
5. Check for oil leaks.
Check hydraulic oil
1. Visually check oil quality.
If the oil looks milky and
foamy, water has entered the
housing. Check for leakage
and replace the oil.
2. Check that the oil is in level
with the sightglass.
3. Fill up if necessary.
Technical data Maintenance
Operating Overview
To Next Page
Loading...
