OXE 125 - Change Engine Oil; Replace Engine Oil Filter

47
Change engine oil
1. Remove the oil draining plug
and washer.
2. Drain the engine oil into a
suitable container.
3. Fit a NEW washer and tighten
the oil draining plug to 9 Nm
(6.6 -lb).
Replace engine oil filter
1. Place a suitable container
below the oil filter.
NOTE! Use a 6-point socket to
remove the oil filter cap.
2. Remove the oil filter cap (1).
3. Remove and discard the oil
filter cartridge.
4. Remove the seal ring (1).
!
CAUTION
Lubricant must be applied to the
threads of the oil filter cap prior
to installation. Failure to lubricate
the oil filter cap threads can
hinder later removal and cause
possible oil filter cap damage.
5. Install the NEW seal ring (1)
with clean engine oil to the oil
filter cap (2).
Technical data
Maintenance
Operating Overview