OXE 125 - Change Coolant

49
5. Remove the sight glass and
washer. Fill up with Hydraulic
oil until the oil comes out at
the upper oil plug (1). Refer
to Recommended fluids and
grease.
6. Clean the sightglass. Install a
new seal.
Tighten to 16 Nm (11.8 -l b).
1. Alternatively, use an oil filling
device and fill up the oil
through the oil plug hole (2)
until oil comes out at oil plug
ho l e (1).
NOTE! Clean the magnetic oil plugs.
Install new seals.
2. Remove the filling hose and
tighten oil plug (2) and (1) to
9 Nm (6.6 -lb).
Change coolant
1. Remove the cap (1) of the
expansion tank (2).
2. Fit a hose (4) to the coolant
drain adapter (3).
3. Drain the coolant/water
mixture into a suitable
container.
4. Remove the hose (4) from the
drain adapter.
5. Fill up with coolant/water-
mixture at the expansion tank
cap up to 4 cm below filling
neck. Refer to Recommended
fluids and grease.
The cooling system of the engine is
to be filled with a mixture of distilled
water and antifreeze based on
ethylene glycol and/or anticorrosion
additive.
Technical data
Maintenance
Operating Overview