Connecting fuel line
Connect the fuel line to the fuel filter.
Engine shut-off cord
OFF START
ON
One clip must be attached to the engine
shut-off switch, the other to a secure place on
the operator’s floating device or wrist. If the
operator falls overboard or moves far enough
away from the operator’s position the engine-
shut-off cord will stop the engine, thereby
prevent the boat from running away under
power.
BREAKING IN THE ENGINE
The OXE Diesel outboard, as well as all new
engines, needs a period of breaking in. This is to
allow mating surfaces of moving parts to wear
in evenly. Correct break-in will help to ensure
proper performance and a prolonged engine
life. Most diesel engines notices an increase in
performance and reduction in fuel consumption
aer 150 hours of breaking in time.
!
CAUTION
Failure in following the break-in procedure
can result in severe engine damage or
reduced engine life.
NOTE! Run the outboard in water and in gear
with a propeller installed as follows.
1. First 2 hours of operation:
Run the outboard at various speed up to
3200 r/min. Full throttle for maximum 1
minute every 10th minute. Do not run the
engine at idle for long periods.
2. Remaining eight hours:
Run the outboard at any speed. Avoid full
throttle for more then 5 minutes.
3. Aer the first 10 hours:
Operate the outboard normally.
To Next Page
Loading...