Check engine oil, hydraulic oil and belt oils
!
CAUTION
Ensure that the outboard is in vertical
position when checking engine oil level, gear
oil level and upper and lower belt oil level.
Check engine oil
1. Remove the engine oil dipstick and wipe
it clean.
2. Completely insert the dipstick and remove
it again.
3. Check that the engine oil level is between
the upper and the lower mark on the
dipstick. If below the lower mark, fill up
with engine oil. If oil level is above dipstick
upper mark drain appropriate amount
of oil. Excess oil level can cause reduced
performance and oil leakage.
NOTE! Be sure to completely insert the
dipstick into the dipstick guide.
4. Check for oil leaks.
Filling fuel
1. Remove the fuel tank cap.
2. Carefully fill the fuel tank with diesel.
3. Securely close the cap aer filling the
tank. Wipe up any spilled fuel.
NOTE! If necessary, refer to Priming the fuel
system.
To Next Page
Loading...
