OXE 200 HP - Replace Propeller

49
Replace propeller
!
WARNING
Do not use any body parts to hold the
propeller when loosening or tightening the
propeller nut.
1. Straighten the cotter pin (2) and pull it out
using a pair of pliers.
2. Remove the propeller nut (1).
3. Remove the propeller and propeller
washer.
4. Apply marine grease according to table
Recommended fluids and grease to the
propeller sha.
5. Install the propeller washer and propeller
on the propeller sha.
NOTE! Be sure to install the propeller washer
before installing the propeller, otherwise
the lower case and propeller boss could be
damaged.
!
CAUTION
Be sure to use a new cotter pin and bend the
ends over securely. Otherwise the propeller
could come off during operation and be lost.
NOTE! We recommend a hub kit when
mounting a propeller. Contact your OXE Diesel
dealer!
Technical data Maintenance
Operating Overview