47
Change coolant
1. Remove the cap (1) of the expansion
tank (2).
2. Fit a hose (4) to the coolant drain
adapter (3).
3. Drain the coolant/water mixture into a
suitable container.
NOTE! Discard used coolant/water mixture
according to local legislation.
4. Remove the hose (4) from the drain
adapter.
5. Fill up with coolant/water-mixture
of 30% at the expansion tank cap up
to 4 cm below filling neck. Refer to
Recommended fluids and grease.
The cooling system of the engine is to be filled
with a mixture of distilled water and antifreeze
based on ethylene glycol and/or anticorrosion
additive.
!
WARNING!
Use only approved fuels, lubricants etc.
see “Recommended fluids and grease”.
Otherwise the manufacturer’s warranty will
become null and void.
Coolant must be added at the filler cap only.
Do not add cold coolant to a warm engine.
Ensure that the mixing ratio “water-antifreeze”
is preserved.
6. Slowly fill up with coolant via filler
neck on expansion tank until fluid level
has reached just above the divider in
expansion tank.
7. Let engine run at a speed of 2,000 rpm for
approx. 15 minutes.
8. Switch off engine, carefully turn the cap to
relieve pressure.
!
DANGER!
Do NOT open cap until pressure is released.
Risk of scalding and burning yourself!
9. Top up to 4 cm below filling neck.
10. Before the next engine start-up (with the
engine cold) check the coolant level and
top up if necessary.
11. Repeat this procedure until no more
coolant can be added.
To Next Page
Loading...
