OXE 200 HP - Shifting; Stopping the Engine

23
!
WARNING
If the failure remains, have the outboard
checked by an authorized technician.
Operating the engine while overheated will
cause engine damage.
Shiing
!
WARNING
Before shiing, make sure that there are no
obstacles near the boat.
!
CAUTION
Warm up the engine before shiing gear.
Until the engine is warm, the speed might be
higher than normal.
N
4. Place control lever in N (neutral) in order
to activate shiing and traction.
Refer to corresponding Control Head
Manual.
Stopping the engine
Let the engine cool off for a few minutes at
idle or low speed before stopping the engine.
Stopping the engine immediately aer operating
at high speed is not recommended.
1. Turn the key to OFF.
2. Remove the key if leaving the boat
unattended.
NOTE! The engine can also be stopped by
pulling the cord and removing the clip from the
engine shut-off switch, then turning the ignition
key to off-position.
Technical data Maintenance
Operating Overview