OXE 200 HP - Starting the Outboard; Prestart Checks

21
STARTING THE OUTBOARD
!
WARNING
Before starting the engine, make sure that
the boat is tightly moored and that you can
steer clear of any obstructions. Be sure that
there are no swimmers in the water near the
boat.
Prestart checks
– Check that the engine ignition switch stops
the engine.
– Confirm that removing the clip from the
engine shut-off switch stops the engine.
– Confirm that the engine cannot be started
with the clip removed from the engine
ignition switch.
OFF START
ON
1. Attach the engine shut-off cord to your
floating device or your wrist. Then install
the other clip on the engine ignition
switch.
!
WARNING
Attach the engine shut-off cord in a secure
way to your clothes/floating device or wrist
while operating the boat.
Prevent the shut-off cord from entangling
with nearby objects and do not attach the
cord to clothing that could tear loose.
Avoid accidental or unintended activation
of the ignition switch. Unexpected loss
of forward motion can cause people and
obstacles beeing thrown forward. Loss of
power also leads to poor directional control.
2. Turn the ignition key to IGN & ACC.
3. Turn the key to START and hold it there
for a maximum of 5 seconds.
4. Immediately aer the engine starts,
release the key in order to return to the
IGN & ACC position.
Technical data Maintenance
Operating Overview