Oxitone 1000M
User Manual Rev. 1.
Page 14 of 39
5.3. PUTTING ON THE WRIST WORN DEVICE
Note: Make sure the device is fully charged before wearing it. See Section 9.1.
Charging the Battery for charging instructions.
Place the device on your hand wrist with the optical aperture elastic concave surface (see below) on
top of the Ulna bone (the knobby protrusion of the wrist). The ON/OFF switch and the company logo
will face towards you.
Then secure the oximeter device by fastening the straps for stable and comfortable use. Avoid
excessive pressure to the monitor application site as a result of fastening the straps too tightly.
Optical aperture elastic concave surface left-hand Ulna bone
Note: If the device does not turn on, refer to “troubleshooting” for additional information.
CORRECT PLACEMENT
Correct placement of device, with the U-shaped part of device on top of the Ulna bone
Caution: Proper placement on your wrist is essential for SpO2 measurements.
Note: The device cannot be worn with the battery charger.
To Next Page
Loading...