Oxitone 1000M - Alarm and Messages

Oxitone 1000M
User Manual Rev. 1.
2
Page 20 of 39
6.6. ALARM AND MESSAGES
Event Message type and duration Vibration type and duration
Power on Oxitone logo and version number is
displayed for aprox. 5 seconds
Strong vibration for 1 second
Signal acquisition on
power up
"Stay still measurement in progress"
message displayed until first
measurement is obtained
NA
Battery depleted "Low battery level" Pop up message
for 15 seconds (or button press).
Strong buzz for aprox. 350msec
Battery Critical "Please recharge battery" Pop up
message, until auto power off after 30
seconds.
Strong buzz for aprox. 350msec
BLE connection request "Press button to connect to…" Pop up
message for 15 seconds (or button
press if user confirms).
Strong buzz for 750msec
No power to charger "Please connect charger to wall
outlet" Pop up message until power
applied
Strong buzz for aprox. 350msec
Charger fault "Charger fault detected" Pop up
message until charger disconnects
Strong buzz for aprox. 350msec
System Error "#xxx Service required" Pop up
message, requires reset to remove.
1 Second