PREVENTIVE MAINTENANCE SCHEDULE PART 8: MAINTENANCE AND SERVICE
– 156 – Y53-6032 (R05/10)
Fuel &
Tanks
Fuel tank straps Tighten to proper torque value of 45 - 70 Lb. ft. (61 - 95 N.m.); *check annu-
ally once strap tension reaches a steady state; i.e., after 2 - 3 retorquings,
the measured torque is the same as previous reading.
XX*
Driveshafts Models 1610-1810 & SPL-90 Lubricate slip member & U-joints X X
Model SPL-100 Lubricate slip member & U-joints X
Models SPL-140/140HD/170/
170HD/250/250HD
Lubricate slip member & U-joints
X
Models SPL-140XL/170XL/
250XL (ON HIGHWAY &
LINE HAUL)
Lubricate slip member & U-joints 360,000 miles/
576,000 km/
every 3 years
Models SPL-140XL/170XL/
250XL (OFF HIGHWAY &
CITY)
Lubricate slip member & U-joints
X
Battery Battery cables Check the condition of the cables, cushion clamps, and routing. Replace a
cushion clamp if the rubber has deteriorated. Repair or tighten terminals,
and secure cables to prevent chafing. Replace damaged cables (cuts,
cracks, or excessive wear) (see page 195
).
XX
Batteries Check for cracks and damage, electrolyte level, condition of terminals, and
tightness of holddowns (see page 195
).
X
Table 2 Preventative Maintenance Schedule (Continued)
SYSTEM COMPONENT MAINTENANCE TASK
Recommended
PM Interval
I ABCDE
Y53-6032.book Page 156 Monday, May 24, 2010 3:37 PM
To Next Page
Loading...
