Pacmac 2015 - VERTICAL HEATER SETUP

2015OPERATIONSMANUAL

51

SET THE VERTICAL
HEATER
 WITH THE TUBE SLIDE ALL THE
WAY IN AND IN THE PROPER
POSITION, CLOSE THE
VERTICAL HEATER AND
SECURE LATCH.
 LOOSEN THE HEATERS VIA THE
2 HANDLES ON EACH BAR.
o HANDLE
 SLIDE THE BARS IN UNTIL THEY
ARE AN 1/8” OF THE ZIPPER
GUIDE. PARALLEL WITH THE
TUBE FROM TOP TO BOTTOM.
o ZIPPER GUIDE
o 1/8 GAP
 OPEN THE VERTICAL HEATER
ASSEMBLY AND LINE THE
OTHER SIDE UP EVENLY AND
TIGHTEN DOWN.
 THE BARS SHOULD HIT ON
CENTER LINE WITH THE ZIPPER
GUIDE FROM TOP TO BOTTOM.