Palax C700 COMBI - 1 BASIC SPECIFICATIONS AND RESPONSIBILITIES; 1.1 Foreword; 1.2 EU Declaration of Conformity; 1.3 Intended use of the machine

1-2018
II
translation
CONTENTS
1 Basic specifications and responsibilities ................................................................... 1
1.1 Foreword ........................................................................................................... 1
1.2 EU Declaration of Conformity .......................................................................... 2
1.3 Intended use of the machine .............................................................................. 3
1.4 Warning signs ................................................................................................... 3
1.5 Type markings ................................................................................................... 4
1.6 The main dimensions and models of the machine ............................................. 5
1.7 Safety instructions ............................................................................................. 5
1.8 Noise emission and vibration ............................................................................ 6
1.9 Responsibilities of the operator ........................................................................ 6
1.10 Operating conditions ......................................................................................... 7
1.11 Terms of warranty ............................................................................................. 7
1.12 Operating instructions for the combustion engine and the winch .................... 8
2 Taking delivery and assembly of the machine .......................................................... 9
2.1 State of delivery and acceptance control .......................................................... 9
2.2 Main parts of the machine................................................................................. 9
2.3 Installation of the adjustment lever for the splitting wedge (Fig. 2) ................. 9
2.4 Assembly of the log-stop, Figure 3 .................................................................. 10
2.5 Topping up hydraulic oil ................................................................................. 10
2.6 Bringing the conveyor into the work position, Figures 4 and 5...................... 10
2.7 Bringing the conveyor into the transport position .......................................... 11
2.8 Lifting and transferring the machine, Figures 6A and 6B .............................. 12
3 DRIVING POWER ................................................................................................. 13
3.1 Powered by a tractor ....................................................................................... 13
3.2 Revolutions range of the PTO-shaft ................................................................ 13
3.3 Stop switch of the tractor-powered machine (Figure 7) ................................. 13
3.4 Automatic tightening of the V-belts (Figure 8) ............................................... 14
3.5 Required measures in an emergency situation................................................ 14
3.6 Selecting the operating mode: powered by tractor or electricity (Figures 9 and
10) 14
3.7 Electric drive, start and emergency stop......................................................... 15
3.8 Starting 15
3.9 Emergency stop of an electric-motor-powered machine ................................ 15
3.10 Starting the electric motor in frost .................................................................. 15
3.11 Honda petrol engine, start, stop and emergency stop ..................................... 16
4 Use of the firewood processor, crosscut operation ................................................. 17
4.1 Preparations before the use of the machine, all models ................................. 17
4.2 Operating the crosscut saw, before the operation .......................................... 17
4.3 During the operation ....................................................................................... 17
4.4 Placing the wood on the deck.......................................................................... 18
4.5 Crosscut operation .......................................................................................... 18