26
translation
7.5 Changing the oil in the angular gear
The oil plug is at the side of the angular gear.
The angular gear must be demounted for the oil change, or the used oil must be
drained, for example, by means of suction drainage.
Fill up with about 0,5 litres of new oil.
The upper limit is at the lower edge of the filling opening.
Oil type SAE 80
NOTE! The combustion-engine-powered machine lacks angular gear and
related parts such as V-belts, belt-tightener or emergency switch.
7.6 Lubricating the machine,
Fig 28
If the machine is left unused for a
longer period of time, lubricate the
shaft bearings A (Figure 28) with
roller-bearing lubricant in
accordance with the table at the
end of the operating season.
NOTE! If the machine is left
standing for a longer period of time,
it is important that the bearings
always be provided with clean
lubricant.
A
Fig. 28. Lubricating the machine
Lubricate daily with oil the moving joints, log-stop, legs of the deck and the support
rollers.
To Next Page
Loading...