Palax C750.2 - Page 3

10.1.1 Crooked trees.....................................................................................31
10.1.2 Big trees............................................................................................. 31
10.1.3 Small trees without splitting............................................................... 31
10.1.4 Re-splitting..........................................................................................31
10.1.5 Trees with large branches..................................................................32
10.1.6 Stuck log - faulty cutting.................................................................... 32
10.1.7 Stuck log - cylinder out of power....................................................... 33
10.2 Alternative power sources..............................................................................33
10.3 PTO powered................................................................................................. 34
10.3.1 Emergency stop................................................................................. 34
10.3.2 Cold start............................................................................................ 35
10.4 Electric motor powered.................................................................................. 35
10.4.1 Rotation direction check.....................................................................36
10.4.2 Start the motor................................................................................... 36
10.4.3 Emergency stop................................................................................. 37
10.4.4 Cold conditions...................................................................................37
10.4.5 Electric heater (for oil tank)................................................................38
11 Circular saw blade operation..............................................................38
11.1 Before the circular saw blade operation.........................................................38
11.2 During the circular saw blade operation.........................................................39
11.3 Cut to equal length (Ergo)..............................................................................39
11.4 Operation on the last log................................................................................40
12 Fully hydraulic control (Palax Pro & Palax Pro+)............................. 41
12.1 Safety device..................................................................................................42
12.2 Joystick........................................................................................................... 42
12.3 Circular saw blade feed rate valve (Pro, Pro+)..............................................43
12.4 Lever for splitting............................................................................................44
12.5 Manual lever for splitting................................................................................44
13 Mechanical control (Palax C750 Ergo)...............................................46
13.1 Safety device..................................................................................................46
13.2 Multifunction lever.......................................................................................... 47
13.2.1 Install the multifunction lever..............................................................48
13.3 Adjustment lever for splitting wedge.............................................................. 49
14 Maintenance instructions.................................................................... 49
14.1 Clean the machine......................................................................................... 51
14.2 Clean, tighten, and lubricate the conveyor chain...........................................51
14.3 Change hydraulic oil...................................................................................... 51
14.4 Lubricate the valve.........................................................................................51
Lubricate the locking head...........................................................................52
Lubricate the spool extension...................................................................... 52
14.5 Lubricate the machine....................................................................................52
14.6 Lubricate the main and blade shaft bearings.................................................53
©
TP SILVA 2023
Version 1.1
Palax C750.2.
ORIGINAL INSTRUCTIONS