40/164 cod. 00 477 1480 - 12/2012 - Palazzetti - PN - Italy
INTRODUCTION
2 SAFETY WARNINGS
2.1 INSTALLATION WARNINGS
The stove assembly and dismantling instructions are
reserved exclusively for specialist technicians.
Users should always contact our service centre to
Before having work performed by other technical
personnel verify their effective technical competence.
Responsibility for work carried out in the place where
the stove is installed lies with the user; the user is also
responsible for making sure the installation checks are
completed.
The user must abide by all local, national and European
safety requirements.
suitable load-bearing capacity.
correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed correctly.
Before starting to assemble or dismantle the stove, the
installer must heed the safety precautions required by
A) do not work in adverse conditions;
and make sure that personal protective equipment
is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
2.2 MAINTENANCE WARNINGS
manual.
other means of protection.
that the stove, if it had been operating, has cooled
down.
calibrated or not working, the stove must be
considered out-of-service.
electronic parts and connectors.
2.3 WARNINGS FOR THE USER
with local, national and European regulations.
outside surfaces. For this reason maximum care
avoid getting burned;
manual.
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
shown in the corresponding chapter of this
manual.
plan.
“Maintenance” in this manual.
suspected breakage or unusual noises.
pot.
power cord.
may affect stability.
anchor.
have completely cooled down.
down.
way as to ensure maximum safety.
off using the procedure described in par. 9.3.
procedure described in par. 15.4.
paragraph 15.4.
to avoid damaging the paintwork.
3 FUEL SPECIFICATIONS
3.1 FUEL SPECIFICATIONS
Pellets (Fig. 3.1) are made from various types of
mechanically compacted wood in compliance with
environmental protection standards. Pellets are the
only fuel that can be used on this type of stove.
in relation to the type and quality of pellets used.
The pellet stove requires pellets with the following
characteristics:
- diameter ~ 6 mm;
To Next Page
Loading...
