cod. 00 477 1480 - 12/2012 - Palazzetti - PN - Italy 51/164
ENGLISH
INSTALLATION
6.5 ASSEMBLY DIAGRAM
Assembly must be carried out by qualified
personnel.
1) Seal
the cladding.
5) Flame-retardant counter hood and load-
bearing structure
material
7) Minimum distance of 1 cm between cladding
and Fireplace
minimum distance of 20 cm.
9) The minimum clearance between the stove and
ignitable materials must be 20 cm.
The minimum distance from combustible
materials must be 20 cm.
To ensure correct installation, the smoke pipe
If the fireplace is installed with a flue that
it should be cleaned thoroughly to avoid
malfunctions and the danger of unburned parts
Improper installation may compromise the
safety of the unit.
access the inside of the stove when it is not in
operation.
it must not have any removable parts, so that
electrically powered and moving parts are not
accessible by the user.
in the radiation area of the hearth, and in any
case not less than 1 m.
6.6 PELLETS LOADING
the hood and connected to the appliance by
assembly instructions contained in the package.
We recommend using only original accessories.
The fall of pellets outside the tank could cause
1
2
3
4
5
6
7
Fig. 6.5.1
To Next Page
Loading...
