Palfinger ILF 33 - 10 Lubrication

ILF 33/44/55 Installation Manual
Rev 1.1 50
10 Lubrication
1. Lower the platform to the ground.
2. Remove red protector caps from each component. Lubricate, grease, and oil per diagram below.
3. Cycle platform up and down several times. Lubricate and grease all points again.
4. Wipe any excess grease and replace all red protector caps on zerks.
6 PLCS
6 PLCS
IN
IN
OUT
Zerk Fitting – 12 places, (3 in the mount frame, 3 in the cylinder/platform area).
IN
OUT
Oil level in the power pack tank (see marking inside of power pack reservoir).
IN
Platform hinges and optional cart stops (use WD-40 lubricant or equivalent).