Check Off Sheet
Revision 1.3 - 29 -
8.2 Decal Placement and Inspection
For operator’s safety, all decals appearing in “Decal Kit” must be in a conspicuous place on control
side of liftgate to be read by operator. This is typically a combination of decals on the liftgate and
truck body. Please make sure to place the maximum capacity decal (D) on driver and curb side.
(A) 1 ATG-URGWA - Urgent warning: Elevating gate instructions
(B) 1 ATG-ILR-ILFS - Operational Instructions
(C) 1 ATG-BKR - Circuit Breaker Reset (must be located at the circuit breaker)
(D) 2 ATG-XXXX - Max. Capacity (please check the serial number plate to find out your specific capacity)
(E) 1 ATG-RESET - Circuit Breaker Protection
(F) 2 ATG-WLH - Warning: liftgate can crush
(G) 2 ATG-CTN - Caution: Always stand clear of platform area
(H) 1 ATG-CAB - Liftgate Shut-Off (Place Decal next to the On-Off Switch in the Cab)
(J) 1 ATG-UD - Toggle Decal
(K) 1 ATG-WNG - Warning: Use handle to open (must be located underneath handle (main section))
To Next Page
Loading...
