Chapter 7 Page 181
7. Enter the initialization string supplied by the documentation for
the modem attached to your cell phone.
8. Tap OK, and then tap OK again to save the configuration.
After you create the configuration, you need to set up the HotSync
Manager of your Desktop application and the HotSync application of
your organizer to perform a modem HotSync operation.
Network preferences and TCP/IP software
The Network Preferences settings enable you to use the TCP/IP
software that is included in the organizer operating system. You can
use the TCP/IP software to connect with Internet Service Providers
(ISPs) or dial-in (remote access) servers. Because the TCP/IP software
is a feature of the operating system, you configure all parameters
relating to it from the Preferences application.
To use TCP/IP, you must create a configuration in Connection
Preferences and then create Network Preferences settings.
Note: The Connection Preferences screen enables you to define
several ways that your organizer can use the modem to
communicate with remote devices. For example, you can
communicate with your ISP server, or with your computer if
you are away on travel. See “Connection preferences” earlier
in this chapter for a complete explanation on how to create
modem configurations.
After you configure both the Connection and Network Preferences,
you can establish a PPP (Point-to-Point Protocol), SLIP (Serial Line
Internet Protocol), or CSLIP (Compressed Serial Line Internet
Protocol) connection with your ISP or dial-in server. You can do this
either by using menu commands from the Network Preferences
screen or by using a third-party application.
Your new configuration appears in
the list of available configurations
To Next Page
Loading...
Need help?
General
