Page 192 Chapter 7
3. Tap the command you want from the Command list. If the
command requires additional information, a field appears to the
right of it for you to enter the information. The following
commands are available:
Wait For Tells your organizer to wait for specific
characters from the TCP/IP server before
executing the next command.
Wait For
Prompt
Detects a challenge-response prompt coming
from the server and then displays the dynamically
generated challenge value. You then enter the
challenge value into your token card, which in
turn generates a response value for you to enter
on your organizer. This command takes two
arguments, separated by a vertical bar (|) on the
input line.
Send Transmits specific characters to the TCP/IP
server to which you are connecting.
Send CR Transmits a carriage return or LF character to the
TCP/IP server to which you are connecting.
Send User ID Transmits the User ID information entered in the
User ID field of the Network Preferences screen.
Send
Password
Transmits the password entered in the Password
field of the Network Preferences screen. If you
did not enter a password, this command
prompts you to enter one. The Password
command is usually followed by a Send CR
command.
Tap here
To Next Page
Loading...
Need help?
General
