- 115 -
∫ If AVCHD scenes do not change smoothly when played back on
another device
The images may be still for several seconds at the joins between the scenes if the following
operations are performed when multiple scenes have been continuously played back using another
unit.
≥ Just how smoothly the scenes will be played back depends on the playback unit. Depending on
the unit used, the images may stop moving and become still for a moment even when none of the
following conditions are applicable.
≥ A continuous recording of motion picture data that exceeds 4 GB may momentarily stop at every
4 GB of data when played back with another device.
With a PC
Problem Check points
When connected by the
USB cable, this unit is not
detected by the PC.
≥ After re-inserting the SD card into the unit, reconnect the
supplied USB cable.
≥ Select another USB terminal on the PC.
≥ Check the operating environment. (l 85, 86)
≥ Connect the supplied USB cable again after restarting the PC
and turning on this unit again.
When the USB cable is
disconnected, an error
message will appear on
the PC.
≥ To disconnect the USB cable safely, double-click the
icon in the task tray and follow the instructions on the screen.
Others
Problem Check points
If the SD card is inserted in
this unit, it is not
recognized.
≥ If the SD card is formatted on a PC, it may not be recognized
by this unit. Use this unit to format SD cards. (l 25)
Principal reasons for not playing back smoothly
≥ When [REC FORMAT] is changed
≥ When the scenes were recorded on different dates
≥ When scenes lasting under 3 seconds have been recorded
≥ When PRE-REC was used for recording
≥ When the Time Lapse Recording is used
≥ When deleting scenes
≥ When scenes recorded more than 99 scenes on the same date
To Next Page
Loading...
