Panasonic AMK3003P74 - Removal and Installation of Terminal Casing

12
<For 7.5kW or below>
<For 11kW/15kW>
3.3 Removal and Installation of Terminal Casing
█
Removal and installation of terminal cover 1 (terminal casing)
〔Removal〕 ① Loosening the screw first, and pull it up lightly while holding the
center bottom edge of the terminal casing.
〔Installation〕 ② Insert the mounting jaw of terminal casing into the slot on the casing,
then lightly press down the center bottom edge of the terminal cover 1.
█
Removal and installation of terminal cover 2 (terminal casing for
main circuit )
〔Removal〕 ① While holding the center part of the terminal casing for main circuit,
pull it up lightly until the mounting jaw releases.
〔Installation〕 ② Insert the mounting jaw of terminal casing for main circuit into the slot
on the casing, then lightly press it down.
<For 7.5kW or below>
<For 11kW/15kW>
Note) The screw with specially designed structure can not be removed from the casing
to prevent dust from entering it.
Note) After installation, make sure that the terminal cover 1 and 2 are fitted in position.