- 29 (E) -
w CONNECTION OF A REMOTE OPERATION PANEL (ROP)
The ROP (AW-CB400) and the camera must be connected with the optional connecting cable AW-CA50T8.
1. Turn the OPERATE switch of ROP to OFF before connecting cables.
2. Connect the 50-pin connector of the connecting cable to I/F REMOTE connector of the camera.
The 10BASE-T cable must be connected to the ROP.
3. Turn the OPERATE switch of ROP to ON and the camera can be controlled remotely by the ROP.
AC Adapter
AW-PS505A
MONITOR
Remote Operation Panel AW-CB400
DC cable with 4-pin connector
(supplied with AW-PS505A)
10BASE-T
cable
Connecting cable AW-CA50T8 (10 m)
DC cable with ø6.5 plug
(supplied with AW-PS505A)
AC Adapter
AW-PS505A
BNC
To Next Page
Loading...
