73
Name Function
(4) Power
: Set the unit to Power ON mode.
: Set the unit to Standby mode.
In the Standby mode, all the buttons on the live screen except for the [Power ON] button
and [Standby] button are disabled.
[Note]
If [Power ON] or [Standby] is selected too quickly, the status selected and the display
shown may not correspond. In a case like this, follow the steps below to restore the
correct status display:
For Windows:
Press the [F5] key on the keyboard of the personal computer.
For Mac:
Press the [Command] + [R] keys on the keyboard of the personal computer.
The pan/tilt position return to the place just before entering STANDBY mode when
returning from STANDBY mode to POWER ON mode.
If the power is turned off, the pan/tilt position returns to the initial state.
(5) Zoom and Focus
: Use this to adjust the zoom (magnification) to 1.0x
: Use this to adjust the zoom (magnification) in the “Tele” direction.
: Use this to adjust the zoom (magnification) in the “Wide” direction.
: Select the speed at which zoom operations are to be performed.
(auto focus)
Click
Auto
to switch between auto and manual focus.
Green
Auto
indicates that the focus is adjusted automatically.
White
Auto
indicates that the focus is adjusted manually.
(manual focus)
Near
Use this to adjust the focus in the Near direction.
It does not work during automatic adjustments.
O.T.AF
When this is pressed while the focus is being adjusted manually,
the focus will be temporarily adjusted automatically.
It does not work during automatic adjustments.
Far
Use this to adjust the focus in the Far direction.
It does not work during automatic adjustments.
(6)
To adjust the image in the horizontal or vertical direction (panning or tilting), left-click the
pad and the buttons.
It is possible to operate with the central grid pattern in the dragged state, with the speed
of the pan/tilt increasing as it approaches the outside of the pad.
To Next Page
Loading...
