113
Web Camera Functions
The unit can be used as a Web camera if you connect the unit and a personal computer or other device with a
commercially available USB cable.
The unit is compliant with USB Video Class and USB Audio Class. The video and audio of the unit can be transmitted
to a personal computer or other device by using communication software or other software.
Set the priority mode to “HDMI/USB", “USB (4K)", or "USB (Video Conference)" before use.
For the connection procedure, refer to “System example 3 (USB connection)”.
Audio can be output from the audio input connector [AUDIO IN] of the unit to a personal computer or other device.
If you set the Priority Mode to USB (Video Conference), you cannot output video via HDMI/SDI, and you cannot
output video via IP transmission. Also, in this mode, the audio output is forcibly turned off.
[Note]
There is no guarantee that operation will be possible with all devices that have a USB port.
IP control, IP video transmission, and PoE+ power supply can be used at the same time as these functions if you
use a LAN cable. However, some limitations will occur to IP video transmission compared with when the priority
mode is set to “IP”. For details, refer to “Priority mode” section.
Using the USB Video with Skype for Business、set the USB Video H.264 to "Disable".
Controllable functions
The following functions can be controlled when the unit is used as a Web camera.
The names of the functions are the names used in Windows. Furthermore, values are shown as decimals.
[ ]indicates the actual function names.
Please do not change the following menu during UVC output.
Priority mode, Frequency, Format, Install Position, Mirror, Mic
Image adjust
[Brightness] >[Picture level]
This can be set in the same way same way as “Picture level” of the menus and Web settings.
Setting range: -4, -3, -2, -1, 0, 1, 2, 3, 4
Chroma level [Chroma level]
This can be set in the same way same way as “Chroma level” of the menus and Web settings.
Setting range: 0 to 10
Equivalent to –3 to +3 of “Chroma Level”.
If the scene mode is set to “Full Auto”, even if this setting is changed, the change will not be reflected on the unit.
White balance [White Balance mode]
This can be set in the same way same way as “White Balance mode” of the menus and Web settings.
Setting value: ATW, AWB A, AWB B, 3200K, 5600K
To Next Page
Loading...
