80
H.264/H.265
Set H.264/H.265 image settings.
Click [Set] to save the configuration.
[Note]
1. This is only enabled when Priority Mode is set to “IP (4K) and “IP”.
2. Only JPEG images can be displayed on web screens.
Stream transmission
[Off, On]
Whether to transmit images is set here. The default is On.
[Note]
[Stream transmission] cannot be configured when the Priority Mode selection is anything other than “IP (4K)” or “IP”.
Codec
[H.264, H.265]
Select the H.264 or H.265 as the image codec.
Image capture size
[640x360, 1280x720, 1920x1080, 3840x2160]
Select the resolution for H.264/H.265 images.
Frame rate
[5fps, 10fps, 15fps, 25fps, 30fps, 50fps, 60fps]
Set the frame rate for H.264 /H.265 images.
5fps, 10fps, 25fps*1, 50fps*2
5fps, 15fps, 30fps*1, 60fps*2
[Note]:
*1 During RTMP transmission, if you choose [3840 x 2160] for Image Capture Size, the selected frame rate may not
be obtained.
*2 not supported when the Priority Mode is set to [IP (4K)].
Max bit rate (per client)
[1024kbps, 1536kbps, 2048kbps, 3072kbps, 4096kbps, 6144kbps, 8192kbps, 10240kbps, 12288kbps, 14336kbps,
16384kbps, 20480kbps, 24576kbps, 32768kbps]
Specify the H.264/H.265 bit rate.
The default is 14336kbps.
[Note] When bit rate is set higher than 8192kbps, the bit rate during RTMPS transmission will be 8192kbps.
To Next Page
Loading...
